A: Preparation:
• FULLY CHARGE BATTERIES PRIOR TO INSTALLATION.
• ONCE CHARGED, POWER THE BATTERIES OFF.
• ENSURE THE CART IS TURNED OFF.
• TAKE PHOTO OF EXISTING CONNECTIONS FOR REFERENCES.
B: Removal:
• DISCONNECT CABLES FROM EXISTING BATTERIES.
• REMOVE THE BATTERIES WITH INCLUDED STRAP.
• CLEAR COMPARTMENT OF CORROSION / DEBRIS.
1. Installation
A: BALANCE YOUR BATTERIES
Batteries cannot be shipped with a full charge, and in rare occasions can be unbalanced with another battery in your kit, This may display a voltage related alarm indication on your gauge.
Additionally, battery cables “NOT” connected to the BUS-BARS precisely as shown on your installation sheet, can also cause batteries to become unbalanced.
A: Quick Start Guide
Busbar contains two bars with four posts each. One bar will be dedicated to positive connections and the other negative / ground.
• Connect the cables from the first battery to first post of each bar.
• Connect the charger leads to the second post of each bar.
• Connect the cables from the second battery to the third post of each bar.
• The final post of each bar will be dedicated to cart connections (controller and solenoid). If cart has aftermarket 12V accessories, the yellow and …See more
This quick start guide will get you on the right path to getting your installation plan in place, and your batteries ready for final installation.
4. Bluetooth Monitoring
Follow this guide graph only if you are going to not be installing the can bus fuel gauge, and monitor the system via Bluetooth only
• FULLY CHARGE BATTERIES PRIOR TO INSTALLATION.
• ONCE CHARGED, POWER THE BATTERIES OFF.
• ENSURE THE CART IS TURNED OFF.
• TAKE PHOTO OF EXISTING CONNECTIONS FOR REFERENCES.
B: Removal:
• DISCONNECT CABLES FROM EXISTING BATTERIES.
• REMOVE THE BATTERIES WITH INCLUDED STRAP.
• CLEAR COMPARTMENT OF CORROSION / DEBRIS.
1. Installation
A: BALANCE YOUR BATTERIES
Batteries cannot be shipped with a full charge, and in rare occasions can be unbalanced with another battery in your kit, This may display a voltage related alarm indication on your gauge.
Additionally, battery cables “NOT” connected to the BUS-BARS precisely as shown on your installation sheet, can also cause batteries to become unbalanced.
A: Quick Start Guide
Busbar contains two bars with four posts each. One bar will be dedicated to positive connections and the other negative / ground.
• Connect the cables from the first battery to first post of each bar.
• Connect the charger leads to the second post of each bar.
• Connect the cables from the second battery to the third post of each bar.
• The final post of each bar will be dedicated to cart connections (controller and solenoid). If cart has aftermarket 12V accessories, the yellow and …See more
This quick start guide will get you on the right path to getting your installation plan in place, and your batteries ready for final installation.
4. Bluetooth Monitoring
Follow this guide graph only if you are going to not be installing the can bus fuel gauge, and monitor the system via Bluetooth only
